专业版新增入库单，修改单位报错：输入的代码不存在或被禁用！实际上单位是选的。如下图所示：
【原因分析】
相关计量单位在基础资料主表 t_item 中缺失。【解决方案】
可参考以下脚本执行处理：
insert into t_item( fitemid,fitemclassid,fexternid,fnumber,fparentid,flevel,fdetail,fname,funused,fbrno,ffullnumber,fdiff,fdeleted,
fshortnumber,ffullname,uuid,fgrcommonid,fsystemtype,fusesign ,fgrcontrol, fonsale )
select funitgroupid,7,-1,fname,0,1,0,fname,0,0,fname,0,0,
fname,fname,newid(),-1,1,0,-1, 0 from
t_unitgroup a where funitgroupid >0 and funitgroupid not in(select fitemid from t_item where fitemclassid =7)
insert into t_item( fitemid,fitemclassid,fexternid,fnumber,fparentid,flevel,fdetail,fname,funused,fbrno,ffullnumber,fdiff,fdeleted,
fshortnumber,ffullname,uuid,fgrcommonid,fsystemtype,fusesign ,fgrcontrol, fonsale )
select fitemid,7,-1,fnumber,fparentid,2,1,fname,0,0,fnumber,0,0,
fshortnumber,fname,newid(),-1,1,0,-1, 0 from
t_measureunit a where fitemid >0 and fitemid not in(select fitemid from t_item where fitemclassid =7)
【注意事项】
正式账套执行脚本前请先做好备份，建议在待测试账套中核实无误后再在正式账套中执行。